REMEMBER:
This control system was designed to operate and work with
a specific Kichler® Ceiling Fan ONLY. It is not recommended for use with
or installation on any other brand of ceiling fan.
Please make sure your Kichler® dealer has selected the correct model
CoolTouch™ Control System for your specific Kichler Ceiling Fan.
WARNING:
This control system is intended for use on 120 volt / 60 Hz
power systems ONLY.
WARNING:
The dimming function on this control system is NOT intended
for use with NON-Dimmable Fluorescent lamps.
6. INSTALLING THE COOLTOUCH™
CONTROL SYSTEM WALL PLATE
7. STORING THE TRANSMITTER
Place the transmitter in the wall pocket by inserting the bottom of the
transmitter first and then press the top of the transmitter into the pocket. The
transmitter will fully function from this location or you can remove it to use
as a "Hand Held" device.
To remove the transmitter from the wall pocket, push the release button and
the transmitter will fall into your hand.
8. TROUBLESHOOTING GUIDE
If the Ceiling Fan and or light fixture(s) fail to respond to commands from
the transmitter, check the following.
● Check the main power supply and reset or turn on the breaker.
● Make sure the "Receiver Unit" is wired properly.
● Light Fixture pull chain switch turned to ON ?
● Good batteries in transmitter ? Replace if needed.
● Transmitter and Receiver "frequency" switches set to match each other ?
NOTE:
The distance between the transmitter and receiver should not be
greater than 30 feet. For best performance, make sure the Black Antenna on
the end of the receiver unit remains extended and not tangled with any of the
electrical wires.
NOTE:
All wiring must be in accordance with the National Electrical Code
and local electrical codes. Electrical installation should be performed by a
qualified licensed electrician.
Select a location to install your CoolTouch™ Control System Transmitter
and Wall Pocket.
REMEMBER,
you can safely use the transmitter outdoors but it should be
stored, while not is use, indoors away from excess heat or humidity.
You can replace an existing wall switch or, install the transmitter wall
pocket on ANY flat surface.
Option 1: Install the control system using an existing wall switch outlet box.
Make sure the electrical power is TURNED OFF at the main panel before
continuing.
NOTE:
Switch installation must comply with all local and national electric
code.
Step 1. Remove the existing wall plate and the old switch from the wall
outlet box. Wire nut the BLACK leads (hot) together and push back inside
the outlet box. (Fig. M)
Step 2. Install the metal plate and CoolTouch™ wall plate to the existing
wall outlet box with 4 screws provided. Then place the two plastic plugs
into the wall plate. (Fig. N)
Option 2: Install the control system on ANY flat surface. Select the desired
location and use the CootTouch™ wall plate to mark the location for the
mounting holes. Plastic wall anchors and screws are provided for this type
of installation.
After installing the wall anchors, attached the CoolTouch™ wall plate with
the mounting screws and then insert the plastic plugs to finish the
installation.
Release
button
Screws
Screws
Plastic plugs
CoolTouch
™
wall plate
Outlet box
Metal plate
Fig. N
Fig. M
Fig. O
Wall plate
Switch
Outlet box
5
