GENERAL INFORMATION
The CoolTouch™ control system is designed to separately control
your ceiling fan speeds, reverse the blade direction and both the
down light and up light (if present on the fan).
The speed button will control each fan speed. HI, Medium, and Low
The reverse button will reverse the direction of the blades.
The off button will shut down the motor.
Each light button will separately control the Up and Down lights if
your fan is equipped with them.
1. INSTALLATION AND OPERATING
INSTRUCTIONS
The Kichler
®
CoolTouch
™
control system is equipped with 16 code
or "Frequency" combinations to help prevent interference from or to
other remote units. The frequency switches on the receiver and
transmitter have been preset at the factory. Please recheck to make
sure both sets of switches are set in the SAME position. Any
combination of settings will operate the fan as long as the switches
on the transmitter and receiver are set in the same positions.
1. SETTING THE CODE
A. Setting the code (frequency) on the transmitter:
a.
Remove the battery cover on the transmitter by pressing on the
cover lid at the point indicated in Figure A
b. Slide each switch to a UP or DOWN position (factory setting is
all UP). Each possible combination (16) of all four switches is
a unique "Frequency". Use a small screwdriver or ballpoint
pen to move the switches. (Fig. A)
c. Replace the battery cover on the transmitter.
B.
Set the code (frequency) on the receiver unit by following the same
procedure as the transmitter, see figure B. Remember to MATCH the
same setting as on the transmitter.
2. INSTALLING RECEIVER IN THE CEILING FAN
WARNING: HIGH VOLTAGE !
Household electrical power can
cause serious injury or death. Make sure the electrical power source
is turned OFF at the main panel by removing the circuit fuse or
switching the circuit breaker OFF.
A.
Installing the receiver unit:
a. Rotate the mounting screw cover on the canopy counter
clockwise, loosen the two mounting screws, rotate the canopy
counter clockwise and let them rest on top of the motor housing.
b. Disconnect the existing electrical wiring between the ceiling
fan and the household supply wires in the ceiling outlet box.
c. Slide the receiver unit into the open space between the top of
the mounting bracket and the mounting ball with the "flat"
side of the receiver facing UP. (Fig. C or D)
The CoolTouch™ Receiver Unit is adaptable to the Kichler
®
Basic
Mounting System (Fig. D) as well as the Kichler
®
Slope Adaptor
Mounting System (Fig. C) or Hugger Style ceiling fan. (Fig. E)
Code switches
Press Here
Code switches
Receiver
Transmitter
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E
ON
ON
1
Mounting Screw
Cover
RECEIVER
RECEIVER
RECEIVER
Motor
Ceiling
mounting
plate
