CoolTouch
TM
control system
4
5. TRANSMITTER PREPERATION AND OPERATION:
A. The CoolTouch™ Transmitter can be used outdoors without any
concern. However, it should be stored, while not in use, indoors and
away from excess heat or humidity.
B. Remove the back cover on the transmitter and install both, 3 volt
(#2032) batteries that were included with the remote control. Make
sure the + sign is facing up and be careful NOT to move any of the
small frequency dip switches. (Fig. K)
Replace the battery cover.
C:
To prevent possible damage to the transmitter, remove these
batteries if not used for long periods of time (months).
D.
Speed Control Buttons:
The
" - - "
buttons:
These three buttons are used to set each fan speed as follows.
Push and Release for operation.
= Low speed = Medium speed = High speed
The
" "
button:
This button turns the fan MOTOR off ONLY (The speed
buttons turn the motor on). Push and Release for operation.
The " " button turns the upper light ON or OFF and also
controls the brightness setting. The " " button turns the bottom
light ON or OFF and also controls the brightness setting. Press
and release the button to turn the light ON or OFF. Press and
hold the button to set the desired brightness.Each light button has
an "intelligent return" feature. Once the desired brightness level
is set and you turn that light OFF, it will return to the same level
of brightness the next time you turn the light ON. If power is lost
to the fan, this setting is lost and must be reset.
The " " button is used to set the fan in forward or reverse
operation. Each time you press and release this button, the fan
blades will reverse direction. This button functions ONLY when
the fan blades are in motion.
Fig. L
Fig. K
