KICstart
Version
1.1.0.x
KICstart User Manual
11
TC Selection & Label
If you choose to assign separate specs for each TC, click the
Edit Specs
button and the screen will now
appear with an additional section for
TC Selection & Label
.
There will be 3 columns:
•
For Defining Specs –
This is where you will select which TC you are creating the spec for. The
bottom left of the screen will also indicate which TC specifications are currently displayed.
•
For Profiling –
When a particular TC is selected from the
For Defining Specs
column, it will
automatically put a check mark in the
For Profiling
box for that TC. This is indicating that that
particular TC will be used during a profile. Make sure to verify that only the TCs that are being used
have a check mark in this column.
Note: When separate specs are being used, this is the only place where you can select or deselect
which TCs will be used for a profile.
•
TC Label –
This area will allow you to type in a description or label to identify that particular TC. If
left blank, the TCs will simply be identified as TC2, TC3, etc.
Maximum Slope between Temperatures
This feature will allow you to determine the maximum slope between 2 specific temperatures in up to 3
different areas across the profile. These specifications are in addition to the standard
Max Slope
over the
Profile. This will allow you to determine the
max slope
, for example, in the initial preheat area, the soak
zone, or from soak up to peak. As with
Max Slope over the Profile
, you will need to also enter the amount
of time in seconds in which slope will be calculated over.
Once you have completed all edits of the specs you can click on the
Green Check button
and your changes
will be applied. Clicking on the
Red X
(Cancel) button will cancel your changes and exit.
Summary of Contents for start
Page 1: ...KICstart User Manual Hardware and Software Version 1 1 0 x ...
Page 2: ......
Page 3: ......
Page 16: ...KICstart Version 1 1 0 x KICstart User Manual 9 ...
