7
Toggle
®
Tables - Dual Motor Height-Adjustable Base, Model EL
Assembly Instructions
Cable Clamp Installation
(optional)
1. Route the power cord for the
Undermounted R8 power module
along the underside of the
tabletop and mark the pilot hole
locations where the cable clamps
will be installed. Four cable
clamps are provided with each R8
power module, but depending on
your configuration not all clamps
may be required (Figure 10).
2. Position the power cord out of
the way. At each marked cable
clamp location, drill a pilot hole
to a depth of
3
/
4
”, making sure to
not drill too deep, piercing the
tabletop (Figure 10).
3. Nest the power cord inside the
cable clamps. Position the cable
clamps over the pilot holes and
secure to the tabletop using
#8 x
3
/
4
” wood screws (Figure 10).
4. Route the power cord to an
approved power source.
Figure 10
Undermounted
R8 power module
cable clamp
(optional)
power
cord
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.