2
Toggle
®
Tables - Dual Motor Height-Adjustable Base, Model EL
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
7. Carefully turn tabletop upside
down on a soft protective surface
and set the base assembly onto
the underside of the top. Position
one base end, so base mounting
holes align with tabletop
mounting holes, and secure base
to top using four M5.5 x 22 pan
head screws. Slide the other base
end into position to align base
mounting holes to the tabletop
holes and secure with four
M5.5 x 22 pan head screws.
Insert and tighten eight M10 x 25
set screws as illustrated, through
the cross-support tubes and
down to the leg-to-leg spanners.
Torque to 4.5 ft/lb to secure
(Figure 2).
8. For 24” deep tables, the control
box must be mounted to the
underside of the tabletop
centered between the cross-tube
assemblies. Position the control
box over the pre-drilled mounting
holes and secure using two
M5.5 x 22 pan head screws
(Figure 2).
9. For 30” & 36” deep tables, the
control box may be mounted to
the underside of the tabletop,
either at the center of the
top between the cross-tube
assemblies (Figure 2), one of
two locations near the front of
the table (Figure 3), or centered
behind the cross-tube assemblies
(Figure 7). If using one of the two
front locations, the built in switch
on the control box will eliminate
the requirement for the key pad
(Figure 3).
M10 x 25
set screws
tabletop
(24 deep)
"
tabletop
(30 or 36 deep)
”
”
M10 x 25
set screws
M5.5 x 22
pan head screws
M5.5 x 22
pan head screws
Figure 2 - 24 Table Depth
”
Figure 3 - 30 & 36 Table Depth
”
”
M5.5 x 22
pan head
screws
M5.5 x 22
pan head
screws
M10 x 25
set screws
M10 x 25
set screws
M5.5 x 22
pan head screws
control
box
control
box
M5.5 x 22
pan head screws
cross-tube
assembly
leg-to-leg
spanner
CAUTION:
If Channels (Wire Troughs) are used they are not to be used for routing
extension cords. Power supply cords are not to be routed across or through more
than one complete unit/worksurface.
