6
Toggle
®
Tables - Dual Motor Height-Adjustable Base, Model EL
Assembly Instructions
Undermounted R8 Power
Module Installation
Note:
The Undermounted R8
power module can be mounted
to the underside of the Toggle
tabletop in one of two pre-drilled
locations, and can face the user
or non-user side of the table.
If desired, the undermounted
power module’s four mounting
holes can be used as a template
underneath the tabletop to mark,
then drill holes for an alternative
mounting location.
1. Position the Undermounted R8
power module to the underside of
the tabletop at the desired
pre-drilled mounting location.
Assure that the power cord can be
routed easily to a power source
(Figures 8 & 9).
2. Align the pre-drilled mounting
holes of the R8 power module
with the drilled mounting holes
underneath the tabletop. Secure
the R8 power module to the
tabletop using four #8 x
3
/
4
” wood
screws. Take care to not over
tighten (Figures 8 & 9).
3. Route the power cord to an
approved power source if
optional mounting clamps are
not desired.
CAUTION:
Risk of electrical
shock. Do not plug into another
relocatable power tap or an
extension cord.
Figure 8
#8 x / ”
wood screw
3
4
Undermounted
R8 power module
pre-drilled
mounting
holes
tabletop
pre-drilled
mounting
holes
Figure 9
#8 x / ”
wood screw
3
4
Undermounted
R8 power module
tabletop
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
