6
Lancaster
®
Auditorium Seating with Power & Data
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Power & Data Module
(optional)
Note:
Power & data
components should be installed
before the seats are assembled.
Simplex Receptacle
1. Secure the receptacle assembly to
the top of the upright gusset
with two
1
⁄
4
-20 x
5
⁄
8
” Torx head
screws and two
1
⁄
4
-20 acorn nuts
(Figure 7).
Note:
If an end panel is attached
to an upright with a simplex
receptacle, the front screw will go
into the threaded insert in the
end panel.
Power Infeed Installation
1. Orient and attach the power infeed
bottom bracket as illustrated, to
the foot of the upright using the
floor fastener bolt which secures
the upright to the floor (Figure 8
& Detail A).
2. Attach the power & data infeed
outer box to the upright arm
gusset at the top, and to the
power infeed bottom bracket
below, using
1
/
4
-20 x
5
/
8
” Torx
head screws and
1
/
4
-20 acorn
nuts (Figure 8).
3. Position the power & data infeed
end cover as illustrated, up to the
installed power infeed outer box
and secure together using
1
/
4
-20 x
5
/
8
” Torx head screws and
1
/
4
-20 acorn nuts (Figure 8).
4. Locate the power infeed harness
and components. Route the
5-wire end of the power infeed
harness through the 90° metal
connector and secure the
connector to the conduit end of
the harness. Next, run the 5-wires
of the power infeed through the
power infeed inside cover and
into, then out through the rigid
conduit straight coupler. Twist
the coupler onto the 90° metal
connector, sandwiching the power
infeed inside cover and tighten
the jamb-nut at the 90° metal
connector side. Route the 5-wires
through the liquid-tight
connector, the liquid-tight
conduit and into the customer
supplied junction box. A
certified electrician, following all
applicable state and local codes
must secure the components
together and attach the power
infeed to building source power
at the appropriate time, verifying
the electrical integrity of the
finished system (Figure 8).
5. Secure the power infeed inside
cover to the power infeed outer
box using four #8 x
3
/
8
” Torx head
screws (Figure 8).
