8
Lancaster
®
Auditorium Seating with Power & Data
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Power & Data Distribution
Note:
Figure 10 illustrates a
three-place unit with power
infeed and typical power
connections, as well as separate
data infeed and routing. When
power is to continue on, as with
four or more seats, a simplex
module end and another power
distribution harness will plug
into the housing end of the first
distribution harness.
Note:
Data wires and data jacks
are to be furnished by customer.
1. At the data infeed location, route
the data wires up through the data
infeed cover and along the seat
backs. Leave enough slack in the
wires to allow for installation of
the wireway covers (Figure 10).
2. Fasten the data bracket to the
simplex receptacle using two
#8 x
3
⁄
8
” Torx head wood screws.
A variety of data jacks can be
accommodated using the pack of
multiple data adapters
(Figure 10).
3. Make the appropriate data wire
connections and snap into the
data adapter (Figure 10).
4. If no electrical distribution is
necessary, see Figure 10 for
wireway cover installation.
Otherwise, continue on to the
next steps.
Note:
Follow the space-planning
layout provided (also reference
power infeed examples) to stage
electrical components as
specified. The simplex receptacle
in each powered upright will have
a length of flexible conduit with
connector end on it. At power
infeed location(s), a power infeed
cover assembly is used to bring
power in. 46”, 49”, and 52”
power distribution harnesses
run to every other seat, passing
power to each individual seating
location. A 25” power distribution
harness is used with a mid-row
power infeed, and at the end of
a row with an odd number of
seating locations.
5. Check to be certain that each
upright is installed with the
correct electrical circuit
designation, as specified in the
space-planning layout.
6. At the power infeed location,
connect the two simplex module
connector ends into the quad
block #1 at the power infeed
harness (Figure 10). Do not
connect the 5-wire end of
the power infeed harness to a
power source at this time.
7. Plug the connector end of the
distribution harness into the
remaining location in the housing
end of the power infeed harness.
Route the housing end of the
power distribution harness
between the next two sets of leg
uprights and connect the simplex
end plug into it as illustrated.
8. Hold the joined electrical
components up against the inside
center of the back panel to
prepare for installation of wireway
covers next page.
