Keysight Technologies U3047AM08, User'S And Service Manual

Page: 53 / 92

U3047AM08
Control Lines
Setting the Control Lines with Address and Data Values
This section describes how to control the rear panel DUT control lines.
Setting the N etwork A nalyzer to Standalone Mode
1. Select Utility > System > Configure > Multiport Capability -OR-
(Instrument > Setup > External Hardware > Multiport > Multiport
Configuration...)
. In the dialog box, select Restart as a standalone PNA > OK .
The following control feature will function only while the network analyzer
is in its Standalone Mode.
Table 1 3
As described in
“Setting the Test Port Paths with Address and Data” on
page 4 7 , the <address>.<data> values are determined in a similar man ne r,
with the following exceptions:
— Table 1 3 will be used
— The <address> value is always 112
Test Set DUT Control Address and Data Logic Table
<Address> <Data> Description Line/Pin
112 0 ALL DUT Control Lines set to logic high or connected to Pin 13 1-8
112 255 ALL DUT Control Lines set to logic low or connected to Pin 14 1-8
112 1 DUT Control Line 1 set to logic low or connected to Pin 14 1
112 2 DUT Control Line 2 set to logic low or connected to Pin 14 2
112 4 DUT Control Line 3 set to logic low or connected to Pin 14 3
112 8 DUT Control Line 4 set to logic low or connected to Pin 14 4
112 16 DUT Control Line 5 set to logic low or connected to Pin 14 5
112 32 DUT Control Line 6 set to logic low or connected to Pin 14 6
112 64 DUT Control Line 7 set to logic low or connected to Pin 14 7
112 128 DUT Control Line 8 set to logic low or connected to Pin 14 8
Keysight U3047AM08 User's and Service Guide 53