Keysight Technologies N5241B, Installation Note

Page: 17 / 42

Installation Note N5242-90122 17
Description of the Upgrade
Installation Procedure for the Upgrade
Step 8.Assemble the A24 Mixer Brick and A22 Splitter
Refer to Figure 1 in this document for this step. New parts are listed in Table 1
on page 9 of this document.
1. Install the A24 mixer brick (5087-7829) to the mounting block by
hand-starting three screws (item
①
; 0515-1410). Do not tighten.
2. Install two screws (item
➁
; 0515-0372) and torque to 9 in-lbs.
3. Go back and torque the three screws (item
①
; 0515-1410) to 9 in-lbs.
Figure 1 A24 Mixer Brick Assembly
Refer to Figure 2 in this document for the remainder of this step.
4. Follow the eleven instructions shown in Figure 2 . If the PNA does include
Option 029A, omit instruction 2 and the unnumbered instruction to install
a splitter - it is already installed. New parts are listed in Table 1 on page 9
of this document.
Graphics in this document such as Figure 2 use very brief text to instruct
where to connect a cable. For example, text that reads “N5242-60018
IFMUX P201 - BRK1 B” means to connect the N5242-60018 gray flexible
cable at the A20 IF MUX board connector P201 and at A23 Mixer Brick 1
connector B.