Keysight Technologies M9260A, Startup Manual

Page: 29 / 45

Inspection, Installation, and Verification 1
Keysight M9260A Startup Guide 29
Figure 1-3 Installing the module to the chassis
4 Hold the module by the injector/ejector handle, and slide it into an available
PXIe or hybrid slot, as shown in Figure 1-3 .
– Install the module into the PXIe slot of the chassis by placing the module
card edges into the front module guides (top and bottom).
– Slide the module to the rear of the chassis and ensure that the injector/
ejector handle is pushed down in the unlatched (downward) position.
– Slide the module completely into the chassis.
– When you begin to feel resistance, push up on the injector/ejector handle
to fully seat the module into the chassis.
5 Latch the module by pulling up on the injector/ejector handle and secure the
front panel to the chassis using the module front-panel mounting screws.
6 Tighten the screws on the module front panel. Performance may suffer if the
screws are not tightened properly.