22 Keysight E8363B/C and E8364B/C Installation Note
General Information
Installation Procedure for the Upgrade Kit
1-
Step 7.Lower and Fasten the Receiver Deck and Connect the Bias Tee
Control Cables
Refer to
for this procedure.
1.
Pull the latch pin (item
✍
) toward the center of the analyzer to release the
receiver deck.
2.
Lift the receiver deck to partially lower it, then release the latch pin (item
✍
). Lower the receiver deck to its fully lowered position and ensure that
the latch pin latches in the lowered position.
3.
With a T-10 TORX driver, install the four screws (item
①
) to secure the
receiver deck.
4.
Connect the bias tee cables to the A16 motherboard connectors as
indicated.
5.
The dc bias input connectors and fuse holders (fuses included) are already
installed on the rear panel but covered. Using a T-10 TORX driver, remove
the four screws from the cover and remove and discard the cover.
Figure 13
Receiver Deck, Lowering
