b. Press the Mode assist key.
c. Press the VOLTS (V) assist key.
1: Single
2 Set the Limit value.
d. Press the Source
assist key.
e. Edit the value as follows or in the same way as for 2-b.
a. Press the Limit assist key.
Limit value is set to
+10 mA.
b. Edit the value as follows or in the same way as for 1-e.
3. Press the Ch1 switch to enable channel 1. This turns the switch green. Channel 1 starts applying
the voltage specified by the Source value. Changing the setup changes channel output immediately.
Performing Measurement
Disabling the Channel
Press the Ch1 switch to disable channel 1.
This turns off the switch light.
Measured value
a. Press the View key to
display the Single view.
Press to start a single measurement.
Press to start a repeat measurement.
* You can change the measurement parameter by
using the Measure assist key.
B2900 applies a constant voltage of +500 mV by the following procedure.
1. Set the source mode and the Source value.
Source is set to +500 mV.
Applying DC Output
This is the measurement example for a 1 k
W
resistor.
(1) Change the value
(2) Press the unit assist
key to fix value
(1) Move the digit pointer
(2) Change the value
(3) Press the rotary
knob to fix the value
