1
2
4
5
6
7 8
9
10
11
12
13
1. Channel number. 1 or 2.
2. Latest measurement data
3. Over voltage/current status indicator (OV or OC)
4. High capacitance mode indicator (HC)
5. Remote sensing (4-wire connection) status indicator
6. Source function. VOLTS or AMPS.
7. Source shape indicator. DC, pulse, sweep, or pulsed sweep. DC does not show the indicator.
8. Source output value, 5½ digit resolution on B2901B/B2902B/B2901BL/B2910BL, and 6½ digit resolution on
B2911B/B2912B
9. Limit (Compliance) value
10. Measurement speed. AUTO, SHORT, MEDIUM, NORMAL, LONG, or MANUAL.
11. Aperture time in seconds or PLC (power line cycle, number of power line cycles per measurement).
Only for the MANUAL speed.
12. Primary measurement data
13. Secondary measurement data or limit test result Pass or Fail
Single View
Range Setup
Sweep Setup
Pulse Setup
Trigger Setup
Source Volts: Spot
Measure Amps
Source Amps: Spot
Measure Volts
Measure Ohms
Constant voltage output range
Current measurement range
Constant current output range
Voltage measurement range
Resistance measurement range
Sweep Parameters
Start
Stop
Points
Step
Sweep mode. LINEAR SINGLE, LINEAR
DOUBLE, LOG SINGLE, or LOG DOUBLE
Sweep start value
Sweep stop value
Number of sweep steps
Sweep step value
Pulse
Peak
Delay
Width
Pulse output ON or OFF
Pulse peak value
Pulse delay time
Pulse width
Trigger
Count
Delay
Period
Trigger
Trigger type. AUTO, SYNC, TIMER, or
MANUAL
Trigger count (number of triggers)
Trigger delay time
Trigger period
Trigger source. AUTO, BUS, TIMER, INTn
(n=1 or 2), LAN, or EXTm (m=1 to 14)
Pulse base value is the same as the Source output value.
(Available for B2901B/B2902B/B2911B/B2912B)
(More > Show Sweep)
(More > Show Pulse)
(More > Show Trigger)
3
