Kewaunee Air Alert 600, Installation And Operating Manual

Page: 43 / 48

43
To Setup the AFA1000 with BACnet protocol using the pushbutton menus: -
1.
Press Enter from the “Requires set up” screen or if the monitor is in the Run Screen Press and
Hold the Enter button for 5 seconds until the Main Menu is displayed.
2. Using the + / - buttons select SET UP, and then select CONFIGURE, then enter the password (the
factory default Password is 0-0-0-0), press Enter to continue.
3. Using the + / - buttons select PROTOCOL, and press Enter, then using the +/- buttons select
BACnet and then press Enter to return to the CONFIG MENU.
4. Using the + / - buttons select BACnet SETTINGS and then press Enter, a sub menu will appear
with the following parameters: -
5.
Using the + / - buttons select the DEVICE INSTANCE parameter and then press Enter, then using
the +/- buttons select the required Instance and press Enter to continue.
6. Using the + / - buttons select the STATION ID parameter and then press Enter, then using the +/-
buttons select the required ID and press Enter to continue.
7. Using the + / - buttons select the BAUD RATE parameter and then press Enter, then using the +/-
buttons select the required rate and press Enter to continue.
8. Using the + / - buttons select the PARITY parameter and then press Enter, then using the +/-
buttons select the required rate and press Enter to continue.
9. Using the + / - buttons select the MAX MASTERS parameter and then press Enter, then using the
+/- buttons select the required number of Masters and press Enter to continue, then select DONE
to return to the CONFIG MENU, then select DONE and RUN.
Parameter Description Range Default
A Device
Instance
Set the slave ID for
the unit
0000000 to 4194303 0000000
B Station ID Set the network ID 0-127 1
C Baud Rate Set the required
Baud Rate
1200/2400/4800/9600/1440/ 19200/38400/57600 38400
D Parity Set the required
Parity
None/Even/Odd None
E Max Masters Set the max
masters (max
devices on the
network)
0-127 1