Kersten K2100, Original Operating Instructions

Page: 8 / 25

8
Safety instructions
•
Only use original spare parts from the manufacturer, as these comply with the technical requirements
and thus the risk of accidents is minimized!
•
Cleaning with the high-pressure cleaner should be carried out so that the water jet is not held directly
in bearings, turned parts, grease nipples, shaft seals, wheel hubs, etc. After each cleaning with the
high-pressure device, the lubrication points must be re-greased. In the case of infringement, the right
to guarantee expires!
•
Check the moving parts for ease of movement and regrease if necessary!
•
After maintenance and cleaning work, be sure to replace the guards and put them in the protective
position!
•
To avoid the risk of fire, keep the machine clean!
•
Regularly check nuts and bolts for tightness and retighten if necessary.
•
When carrying out maintenance, cleaning and repair work on the lifted device, always make sure that
it is protected by suitable support elements!
•
Before carrying out any repairs, make sure that the hydraulic system is depressurised, because fluids
under pressure can penetrate the skin and cause serious injuries! Therefore
•
See a doctor immediately - danger of infection!
•
Repairs may only be carried out by qualified personnel.
•
When working on the electrical system, always remove the earth strap from the battery!
•
Check the hydraulic hose lines for damage and aging at regular intervals and replace if necessary.
•
When welding the tractor or mounted equipment, disconnect the battery.
•
Repairs such as welding, grinding, drilling, etc. must not be performed on structural and other safety-
related parts such as frames, axles, etc.
3.2.9 Engine, fuel and oil
•
Before refueling, switch off the engine and remove the ignition key (if available)!
•
Do not top up with fuel and do not spill fuel (use a suitable refilling aid). If necessary, take up
spilled fuel immediately.
•
Dispose of oils, fuels and filters separately and properly!
•
When handling fuel, caution is required, increased risk of fire. Never refuel near open flames,
hot engine parts, and sparks when flying. Do not smoke when refueling!
3.2.10 Electrical system and battery
•
When working on the electrical system, always disconnect the battery (negative pole) (if
present).
•
Make sure the connection is correct - first positive pole and then negative pole!
•
Be careful with battery gases - Explosive!
•
Avoid sparks and open flame near batteries.
•
Take care when handling battery acid - corrosive!
•
Always provide the positive pole with the intended cover or terminal protection cap.
•
Caregivers of pacemakers must not touch the live parts of the ignition system while the engine is
running!