KEPCO KLP 10-150-1.2K, User Manual

Page: 58 / 84

3-18
KLP031308
4. Tap the DC OUTPUT switch to accept the new settings (blinking stops) or use a thin tool
(e.g., a paper clip) to press the FUNCTION switch to cancel the operation.
5. To exit, rotate either VOLTAGE or CURRENT control until the status display reads
RTN
,
then tap the DC OUTPUT switch. To exit the
UTIL
menu rotate either VOLTAGE or CUR-
RENT control until the status display reads
EXIT
, then tap the DC OUTPUT switch.
3.2.13.7 CALIBRATION
Refer to PAR 4.3.
3.3 REMOTE MODE PROGRAMMING USING DIGITAL INTERFACES
For digital remote programming refer to the KLP Developer’s Guide.
3.3.1 FACTORY DEFAULT SETTINGS
3.3.1.1 GPIB FACTORY DEFAULTS
The factory default GPIB address is 6; refer to PAR. 3.2.9 to change the GPIB address.
3.3.1.2 RS 232 FACTORY DEFAULTS [-1200 MODELS ONLY]
The factory default RS 232 settings are as follows; refer to PAR. 3.2.10 to change the RS 232
baud rate (-1200 Models only):
• Baud rate: 38400
• Parity: None
• Data Bits 8
• Stop Bits 1
• Echo OFF
• XON ON (enabled) NOTE: Kepco strongly recommends the XON XOFF method
for data transfer via RS 232 protocol for all Kepco products. If this method is
not selected, it is the user's responsibility to ensure completion of any
response by the power supply prior to issuance of subsequent commands.
3.3.1.3 LAN FACTORY DEFAULTS [-1.2K MODELS ONLY]
The factory default LAN interface settings are listed below. Factory default setting can be
restored using the LAN Reset function (front panel only) or configured as desired from either the
front panel (see PAR. 3.2.12) or the web interface (see PAR. 3.3.6.3 )
• DHCP: ON
• AUTOIP: ON
• PING: ON (can only be changed through web interface)
• IP Address: Undefined
• MASK Address: 255.255.0.0
• GATE Address: 0.0.0.0
• DNS Address: 0.0.0.0