KEPCO KLP 10-150-1.2K, User Manual

Page: 52 / 84

3-12
KLP031308
the address, press DC OUTPUT switch, then rotate VOLTAGE control to change
192._
or CURRENT control to change
168._
, then press DC OUTPUT switch to save.
•
IP2
- Shows second half of IP address (e.g., for IP address 192.168.000.200 the DC
VOLTS display shows
_000
. and the DC AMPERES display shows
_200
). To change
the address, press DC OUTPUT switch, then rotate VOLTAGE control to change
_000
.
or CURRENT control to change
_200.
, then press DC OUTPUT switch to save.
•
MSK1
- Shows first half of SUBNET MASK address (see IP1 described above). Default is
255.255.
•
MSK2
- Shows second half of SUBNET MASK address (see IP2 described above).
Default is 0.0
•
GTE1
- Shows first half of GATE address (see IP1 described above).
•
GTE2
- Shows second half of GATE address (see IP2 described above).
•
DNS1
- Shows first half of DNS address (see IP2 described above).
•
DNS2
- Shows second half of DNS address (see IP2 described above).
•
RTN
- Return to
LAN
menu.
3.2.13 UTILITY FUNCTION
The Utility Function provides additional system information or access to special functions.
These are described below.
1. If the status display shows
SET
, tap either the CURRENT or VOLTAGE controls to take the
unit out of setpoint mode (status display goes from
SET
to blank)
2. Using a thin tool (e.g., a paper clip), press the FUNCTION switch once until the status dis-
play reads
VIRT
, then rotate either the VOLTAGE or CURRENT control in either direction
until status display reads
UTIL
.
3. Tap the DC OUTPUT switch once, then rotate either the VOLTAGE or CURRENT control in
either direction to select the function identified in the status display (see below).
•
VERS
- Display System Firmware Version (see PAR. 3.2.13.1)
•
MODL
- Display Model (see PAR. 3.2.13.2)
•
RELY
- Relay Control (see PAR. 3.2.13.3)
•
QkBT
- Quick Boot (see PAR. 3.2.13.4)
•
SYST
- System Configuration (see PAR. 3.2.13.5)
•
INVC
- Analog Input Voltage and Current A to D calibration voltages (see PAR. 3.2.13.6)
•
LBT
- [-1200 Models only] Loop Back Test used to isolate RS 232 communication prob-