56
11
4
Press
[OK]
to program the identified code in place of
the currently set code.
• The DCS function will remain ON. You can press
[TONE]
to switch the DCS function OFF.
• Press
[ESC]
if you do not want to program the identified
code.
• Press
[SCAN]
while the identified code is blinking, to
resume scanning.
Note
: Received signals are audible while scanning is in progress.
DCS CODE ID
This function scans through all DCS codes to identify the
incoming DCS code on a received signal. You may find
this useful when you cannot recall the DCS code that the
other persons in your group are using.
1
Press
[TONE]
to switch the DCS function ON.
• “DCS” appears when the DCS function is ON.
2
Press
[F]
,
[T.SEL]
.
• The current DCS code appears and blinks.
3
Press
[SCAN]
to activate the DCS Code ID.
• “DCS SCAN” appears and blinks.
• Scan starts when signals are received.
• To reverse the scan direction, turn the
Tuning
control
clockwise (upward scan) or counterclockwise
(downward scan). You can also press Mic
[UP]
/
[DWN]
.
• To end this function, press
[ESC]
.
•
When the DCS code is identified, the identified code
appears and blinks.
Summary of Contents for TM-V708A
Page 92: ......
