Kenwood TK-2160, Instruction Manual, Page: 18 / 218

10
If you are not using a speaker/
microphone, install the cover over
the speaker/ microphone jacks by
sliding the cover’s tab into the slot
on the side of the transceiver until
it snaps in place.
Note: To keep the transceiver water
resistant, you must cover the
speaker/ microphone jacks with the
supplied cover.
I
NSTALLING THE
C
OVER OVER THE
S
PEAKER
/ M
ICROPHONE
J
ACKS
Note: When installing the speaker/ microphone jack cover, you must
remove the battery pack from the rear of the transceiver.
I
NSTALLING THE
(O
PTIONAL
) S
PEAKER
/ M
ICROPHONE
Note: When installing the optional speaker/ microphone and its
locking bracket, you must remove the battery pack from the rear of
the transceiver.
1 Insert the speaker/
microphone plugs into the
speaker/ microphone jacks.
2 Attach the locking bracket
using the supplied screw.
Note: To lift the locking bracket after
it has been installed, use a piece of
hardened plastic or metal, such as a
small screwdriver. Lift the bracket by
its tab, beside the screwhole, taking
care not to damage the bracket.