Kenwood TK-2160, Instruction Manual, Page: 17 / 218

9
Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and turning
it clockwise until secure.
I
NSTALLING THE
(O
PTIONAL
) A
NTENNA
I
NSTALLING THE
B
ELT
C
LIP
Note: When installing the belt clip, you must remove the battery
pack from the rear of the transceiver.
1 Remove the 2 screws from
the rear of the transceiver,
then remove the small,
plastic black covering that
was held in place.
2 Insert the belt clip mount
into the space on the rear of
the transceiver.
3 Using the 2 screws, affix the
belt clip in place.
Note: Do not dispose of the plastic
black covering! If you remove the
belt clip, replace the covering into the
space on the rear of the transceiver.
Either this covering or the belt clip
must be in place, otherwise the
battery pack may not remain installed
properly.