KENT INDUSTRIAL (USA) INC.
1231 Edinger ave.,Tustin,CA.92780 U.S.A.
Tel
：
(714)258-8526 Fax : (714)258-8530
2 - 2
(10) Please notice on the air pressure pipes, wires, NC controller, and other
devices, when the slings are pulled.
(11) Please confirm that there are no people on the top of the machine, on the
side of the machine, and on the way of move before moving the machine.
(12) Please remove the objects occupied on the way, and pay highly attention on
the control buttons.
(13) The length of the slings on four corners should be same, and the distance of
four corners between the machine and the ground should be kept the same
when lifting (50 cm suggested).
(14) Please notice on the ground when putting down the machine in order to
confirm there are no wires, pipes under the machine.
2. Forklifter:
(1) During the carry and unloading, please avoid compression or collision
because of the fact this machine is a high precision machine. (The speed
must be lower than 25m / min)
(2) Jog the table to the machine’s center, and the head to the bottom. Then fix
the head by stationary barrier.
(3) The counterweight is locked by the stationary barrier.
(4) Place a pad between the doors, pull them closed, and secure them with two
wire ties through the handles.
(5) The lube unit’s exhausting holes must be locked.
(6) The carry method and the lifter should be totally inspected.
(7) The crane or forklifter’s operator should be well trained or experienced.
(8) Please remove the objects occupied on the way, and pay highly attention on
the control buttons.
(9) Please confirm that there are no people on the top of the machine, on the
side of the machine, and on the way of move before moving the machine.
(10) Please notice on the ground when putting down the machine in order to
confirm there are no wires, pipes under the machine.
Property of Kent Industrial USA
Do Not Reproduce
