![background image](http://html.mh-extra.com/html/kensington/v18p01bp25eu/v18p01bp25eu_instruction-manual_664426008.webp)
Operation
2. Place the bracket in the desired position
and using a pencil, mark the position for the
two screw holes. Using a ruler, draw a line
joining the points marked for the two
screws and using a spirit level, check that it
is on the same level.
3. If fixing to a masonry wall, use a masonry
drill bit, drill holes to a depth of 30mm and
insert the wall plugs.
4. If fixing to ceramic tiles, use a tile and
glass drill bit to drill through the tile and
then drill holes to a depth of
approximately 32 mm using a masonry drill
bit. Insert the wall plugs beyond the depth of
the tile.
5. Hold the bracket into position, align the fixing
holes in the bracket with the wall plugs and
insert the screws until the bracket is
held firmly into position
6. Fit the nozzles onto their storage posts,
and insert the assembled vacuum cleaner
into the bracket (fig.7).
Notes:
•
If fixing the bracket to timber, follow the
directions above, but
only drill a small pilot
hole for each screw and do not use wall plugs.
This fitting is not suitable for mounting onto
doors.
•
If fixing to hollow plasterboard walls, use a
drill bit suitable for
wood and use wall
anchors suitable for cavity walls.
For
maximum strength locate into wall
studs and cross braces if
possible.
Fig. 7
7