Kemper 345plus, Operator'S Manual

Page: 29 / 126

Attaching to a Claas forage harvester
KM00321,0000881 -19-26FEB19-1/4
Continued on next page KM00321,0000881 -19-26FEB19-2/4
Attaching to a type 498 forage harvester with
variable header drive
Rotary harvesting units for the Claas type 498 forage
harvesters are technically prepared for the variable
header drive.
In addition, programming steps are required in the
forage harvester software, which must be matched
with Claas. To do this, contact your Claas dealer.
IMPORTANT: In order to use the variable header drive,
the module A130FAM must be programmed
for it. Otherwise, the rotary harvesting unit
can only be used with constant speed and the
adjustment of the header speed is carried out
via the Kemper multi-speed transmission.
Programming of the module A130FAM is done via the
forage harvester. To do so, proceed as follows:
1. Attach the rotary harvesting unit to the forage
harvester.
2. Connect the forage harvester to a computer and start
the Claas Diagnostics System (CDS).
3. Select the A130FAM module for programming the
rotary harvesting unit.
KM359969
—UN—22FEB19
4. When entering a serial number, enter released by
Claas.
IMPORTANT: Enter a serial number of a rotary
harvesting unit that corresponds to the working
width of the Kemper rotary harvesting unit.
KM359968
—UN—22FEB19
20-2 031519
PN=29