Lubrication and Maintenance
KM00321,000019A -19-12JUN09-1/1
OUKM001,0000014 -19-15FEB05-1/1
ZX,688RHU009812 -19-01NOV97-1/1
Every 3 Years—Change Coolant of Main Drive Friction Clutch
CAUTION: Never attempt to open drain or filler
plug (B) when the friction clutch is hot! Wait until
friction clutch has cooled down. First loosen
plug (B) by one turn to relieve pressure.
The cavity of the friction clutch (A) can be drained and
refilled. This service work requires the friction clutch to
be removed from the machine. Therefore it is advised
to contact your KEMPER dealer to drain/refill the friction
clutch.
Specification
Main drive friction clutch
cavity—Capacity........................................................ 1.3 L (0.26 US gal.)
ZX1040656
—UN—12APR07
ZX024271
—UN—07MAR01
At the Start of Every Harvesting Season
Before putting the harvester into operation, carry out a
general check of the friction clutches in the main drive,
and do a check on the gatherer drums. In the "Service"
section, see "Relieving Pressure at the Slip Clutches on
the Main Drive".
Run the rotary harvesting unit for a few minutes. Then
check all the bearings. If overheating or excessive play
is found, replace the relevant bearings before operating
the rotary harvesting unit.
Daily Maintenance (Or More Often if
Necessary)
Check all cleaners (blunt or incorrectly positioned cleaner
will cause plugging and expose drive system and friction
clutches to unnecessary load).
After operating for a few hours check that all bolts are firmly
seated; this also applies after changing blades or cleaners.
Clear the area around the gathering drums, rotating
blades and scrapers of husks and bits of stalk.
Check all transmissions for signs of oil leaks.
Check cutting blades and replace them if worn (dull
blades will cause extremely long stubble and expose drive
system and friction clutches to unnecessary load).
50-12
031519
PN=106
Summary of Contents for 345plus
Page 6: ...Contents iv 031519 PN 4 ...
Page 126: ...Index Index 4 031519 PN 4 ...
