Operating Manual PT 18x
21
TSP_
Plausibility
Threshold **
For ATD function, see Chap. 11.1
TSP~
Plausibility
Threshold **
For ATD function, see Chap. 11.1
ANO
Display mode during
Sampling time**
T=0
show lower limit of temp. range dur-
ing running measurement
T.HLD
Hold previous temp. reading during
running measurement
A.RST
Auto reset
For ATD function, see Chap. 11.1
CH.L.2
Li2 check on tAct
For ATD function, see Chap. 11.1
END
End
Save changes / exit menu
*
Only available with Min/Max and Double Max modes
**
Only available with ATD function
12.1.2 One-colour (single-wavelength) measurement:
Spectral channel 1: config. layer
C002
Spectral channel 2: config. layer
C003
In the factory default configuration, all parameter settings for spectral
channels 1 and 2 will be hidden.
Parameter Function
Explanation
E.TB.1
No. of material con-
stants (array length)
Select the quantity of elements you would like
the array of material constants to contain.
Max. array length is 10 (up to 10 constants).
EPS.1
Emissivity factor L1
E.IDX
Set pyrometer to
material constant
Choose one of the stored constants from the
array, e.g. E. 02, for the application
E. 01
Assign material con-
stants
Customize the array: assign a value to each
of the material constants in the array.
TAU.1
Transmittance factor
BAC.1
Ambient temperature
compensation
BAC.T
Temp. of ambient
source of radiation
BAC.%
Influence of ambient
IR radiation
The reflected thermal radiation from the sur-
roundings as a portion of the total IR radiation
collected by the sensor in %
LIN.1
Temperature offset
using linear
OFF
off
2-10
number of nodes used
L. X1
node x 1 - 10
Signal input (initial value) node n
L. Y1
node y 1 - 10
Signal output (resulting value) node n
FIL.1
Smoothing filter
OFF
smoothing not activated
ON
simple smoothing
AUTO
subsequent smoothing (only model
PA1x)
FIL.T
Smoothing time
time t98 in sec for simple smoothing
MEM.1
Min/Max memory
OFF
off
MIN
lowest (min.)temperature, single