Operating Manual PT 18x
24
output inverted)
BU2.T
Buzzer switching
threshold
Switching threshold
(only available at function “Level”)
BU2.H
Buzzer signal
threshold
Hyst/- relative to signal threshold
(only available at function “Level”)
BU2._
Buzzer lower limit of
range
Lower limit of range for switch signal
(only available function “range”)
BU2.~
Buzzer upper limit of
range
Upper limit of range for switch signal
(only available function “range”)
BUZ.L
Buzzer delay time
BU2.M
Buzzer hold time
END
End
Save changes / exit menu
**
Only available with ATD function
12.1.4 General Functions (Configuration layer:
C011
)
Parameter Function
Explanation
A.OFF
Auto switch-off
OFF
automatic switch-off function deac-
tivated
1-60
time period in seconds for auto
switch-off delay
A.STR.
Auto temp. data ouput
OFF
automatic temp. data output is off
ON
temp. data output at PC terminal
A.CYC.
Cycle for auto temp.
data output
Select cycle time in s
ADDR.
Device address
Enter address of device for non-terminal
mode
DISP.
Display control
"ON"
display panel indicates
“on“
IA1
indicate temperature reading accord-
ing to operating mode
mode
UNIT
temperature unit
°(
degrees Celsius
°F
degrees Fahrenheit
MENU
Menu-Mode
NORM
With
marked parameter are not
shown
FULL
All parameters are shown
END
End
Save changes / exit menu
12.1.5 Displayed temperature readings/ Signal intensity
(Configuration layer:
C020
)
Parameter Function
Explanation
Q.
two-colour/ratio temp.
reading
Shows current temperature reading in two-
colour mode
L1.
Temp. reading
Lambda 1
Shows current single-colour temperature
reading for L1
L2.
Temp. reading
Lambda 2
Shows current single-colour temperature
reading for L2
Q. PR.
Temp. reading two-
colour mode without
Shows current temperature reading in two-
colour/ratio mode prior to peak picker