Chapter 5
76
Data appears to
be invalid.
An open connection
exists.
Check your wiring and fix any open
connections; see the instructions in the
KUSB-3100 Getting Started Manual
.
A transducer is not
connected to the
channel being read.
Check the transducer connections; see
the instructions in the
KUSB-3100 Getting
Started Manual
.
The module is set up
for differential inputs
while the transducers
are wired as
single-ended inputs
or vice versa.
Check your wiring and ensure that what
you specify in software matches your
hardware configuration; see the
instructions in the
KUSB-3100 Getting
Started Manual
.
Computer does
not boot.
The power supply of
the computer is too
small to handle all the
system resources.
Check the power requirements of your
system resources and, if needed, get a
larger power supply; consult the module’s
specifications on
of this manual.
Table 4: Troubleshooting Problems (cont.)
Symptom
Possible Cause
Possible Solution
Summary of Contents for KUSB-3100
