Series 3700 System Switch/Multimeter User's Manual
Section 5: Basic Digital Multimeter (DMM) Operation
3700S-900-01 Rev. C / July 2008
5-37
NOTE
If the Series 3700 is in remote mode (controlled over the bus) press
the
EXIT
key to place it in local mode to control the unit using the front
panel keys. The front panel keys are not available on all models.
To enable offset-compensated ohms, the Series 3700 must be in
4W mode.
To enable/disable dry circuit ohms from the front panel:
Figure 5-20: Enabling dry-circuit ohms
NOTE
The Series 3700 is in 4-wire ohm mode when the 4W is displayed.
Dry Circuit is active when the DRY+ is displayed (see the above
figure).
1. Press the
CONFIG
key
(1).
2. Press the
DMM
key
(2).
3. Turn the navigation wheel (3) to scroll to the "DRYCIRCUIT" menu item.
4. Press the navigation wheel (3) to display ON/OFF settings for dry circuit
ohms.
5. Select "ON" or "OFF" and press the navigation wheel (3) again.
6. Press the
EXIT
key
to leave the menu.
Figure 5-21: Four-wire Ohm ATTR MENU: DRYCIRCUIT
NOTE
When enabled, the dry circuit ohms annunciator is on (DRY+).