![background image](http://html.mh-extra.com/html/keiser/m-series/m-series_assembly-and-operation-manual_661500014.webp)
M3i INDOOR GROUP CYCLE
14
Apply a rust and corrosion inhibitor to the Left Bottom Bracket Bearing and to the clip-in
area of each Pedal (recommended after assembly and annually thereafter, see Figure 6).
When all assembly requirements have been met, and you have read and understood
the Important Safety Instructions, test ride the bike. Fine-tune and adjust the Seat and
Handlebar height/depth and Base Stabilizer as needed. It is recommended that the bike
be pedaled in the forward direction.
Proper Operation Check:
•
All Screws are tightened or torqued properly (refer to “How to Assemble the M3i Bike”
section, beginning on page 10, Steps 2 — 12).
•
The Computer Display powers ON (pedal one full revolution) and the Resistance Lever
cycles GEAR 1—24 (GEAR 88 = Emergency Brake).
•
Bike is properly stabilized, level to the floor (refer to “Base Stabilizer” section below).
•
The Seat and Handlebar height/depth are properly set (refer to “Seat/Handlebar Height
Adjustment Knob” and “Seat/Handlebar Depth Adjustment L-Handle” sections, page 15).
Figure 6. Rust & Corrosion
Inhibitor Application
Figure 7. Transporting the Bike
PROPER OPERATION CHECK
TRANSPORT
BASE STABILIZER
To position the bike at the desired location refer to Figure 7 and
follow the instructions below:
Be sure there is a minimum of 24 inches (610 mm) free space
for the bike on all sides before placement.
1. Grasp the Handlebar with both hands.
2. Tilt the bike toward you until the Transport Wheels contact
the floor.
3. Roll the bike to the desired location; tilt it slowly away from
you to set down.
The bike must be placed on a flat, level surface. If the sub-floor is not
level, the Base Stabilizer allows for stabilization.
To stabilize the bike, refer to Figure 8 and follow the instructions
below:
1. Hold the Seat steady, then with your foot, swipe the Base
Stabilizer counter-clockwise to drive it back into the base. This
will un-stabilize the bike.
2. Slightly push across the Seat, until the Base Feet at all three
corners contact the floor, then hold.
3.
With the three Base Feet making contact with the floor, swipe
the Base Stabilizer clockwise with your foot until the Base
Stabilizer makes contact with the floor. This will stabilize the
bike.
Test for stability. The bike should sit flat without rocking. Adjust and
fine-tune the Base Stabilizer as needed.
NOTE: The bike should not be used until it is stabilized. If the bike is
moved to a different location, adjust the Base Stabilizer as needed
to stabilize the bike.
WARNING: To reduce the risk of serious injury, read all important precautions and instructions in this manual
and all warnings on the bike before operation. Failure to perform the Proper Operation Check prior to operation of
the bike will void your warranty and could result in serious injury.
Figure 8. Base Stabilizer Adjustment
2
1
3
Floor