![background image](http://html.mh-extra.com/html/keiser/m-series/m-series_assembly-and-operation-manual_661500012.webp)
M3i INDOOR GROUP CYCLE
12
Tab
9
11
(a) Clean the Pedal threads
using a clean cloth and apply
Loctite
®
242 (threadlocker,
Item G) to the leading threads.
(b) Install the Pedals into the
Crank Arms:
• Start the Pedals into the Crank Arms by hand.
• NOTE: The LEFT Pedal is reverse-threaded.
• Restart if you feel resistance or if the Pedal does
not drive straight into the Crank Arm.
•
Tighten the Pedals (Tool: 15 mm Open-end Wrench).
• Torque the Pedals to 35 ft-lbs/47 Nm (Tool: Torque
Wrench with 6-inch extension and 15 mm Crowfoot).
Handlebar Slide installation.
a) Remove the four Screws from the Handlebar Tube
using a 6 mm Hex Socket Bit and Ratchet (NOTE: Anti-
seize lubricant on the Screws can create messy work;
handle with care).
b) Position the Handlebar Slide (Item I) onto the
Handlebar Tube; numbers face up, screw holes aligned.
c) Install the four Screws, hand-tight only (use a 6 mm
Hex Socket Bit for easier reach). Then, torque the Screws
to 18–20 ft-lbs (25–27 Nm) in a crisscross pattern using
a 6 mm Hex Socket Bit and Torque Wrench. Repeat the
torque procedure (crisscross pattern) to ensure proper
installation.
Install the Media Tray by wedging it in between the
Handlebar.
Assembly is now complete. Continue to “Set Up and
Operation” on the following page.
Be sure to perform the “Proper Operation Check”
(page 14) before use.
10
12
Handlebar installation.
HOW TO ASSEMBLE THE M3i BIKE
WARNING: Failure to follow these instructions will
result in mechanical failure and can cause serious injury.
Torque: 18–20 ft-lbs
(25–27 Nm)
Crisscross Pattern
Handlebar Slide
Handlebar Tube
Four Screws
(a) Disassemble the L-Handle
(Item K) by removing the
Screw using a 5 mm Hex Key.
(b) Insert the Stud through the Handlebar Spacer (tab
pointing down and facing toward the bike), through the
Handlebar Slide slot, and screw into the Handlebar.
(c) Place the L-Handle onto the Stud, pointing away
from the Bike. Re-install the Screw and Washer using a
5 mm Hex Key. Finish with Cap.
L-Handle Assembly
Screw
Handlebar
Handlebar
Spacer
Stud
Loctite
®
242
Right Pedal
Left Pedal
R
Pedal
L
Pedal
15 mm Wrench
Crank Arm
Torque Wrench
with Extension and
15 mm Crowfoot
L Handle
Washer and
Screw
Cap