KL25164 -
Cannular Fully Automatic - Single Lane
Page
9
of
13
Last Updated 1/07/2022 9:44 AM
2.6
–
Can Platform Raising Apparatus
This section will require adjustment again if you are
not
using 500mL cans.
2.6.1
–
Ensure your air supply is still turned off.
2.6.2
–
Place the previous can you have tested with the lid dropping apparatus further forward onto
the can lifting platform.
2.6.3
–
Unscrew the locking nut underneath the filling/seaming table that is connected to the
platform with a 32mm Spanner for the Bump Stop Shaft and a 24mm Spanner for the Locking Nut.
Depending on the can size you are using.
2.6.4
–
Rotate the bump stop shaft further down with your hand. Its best to go further down than
you need.
2.6.5
–
Now using a small amount of force, raise the shaft so that the can engages with the chuck.
This is easier to do with your hand cupping the base of the shaft.
2.6.6
–
Once the can feels firm and in place, rotate the Bump Stop Shaft upwards until it touches the
piston block. Followed by the locking nut. Then use the two spanners again to tighten against each
other.
2.6.7
–
Connect pressure and test in Paused/Manual Operation with
“Canned Lift” Function. The can
should not get crushed, nor should it not be touching at all.
