KL25164 -
Cannular Fully Automatic - Single Lane
Page
5
of
13
Last Updated 1/07/2022 9:44 AM
2.2
–
Compressed Air Inlet
All pneumatic actuators and the Airblade Dryer run from the
air inlet shown below.
Inlet Fitting = 8mm OD Push In Fitting.
Requirements: The Cannular requires an inlet air pressure of
100psi (7 BAR) to function optimally.
The Filter / Water trap will need to be emptied on a regular
basis depending on your air quality.
All pneumatics are pre-lubricated, but you will be required to
fill the pneumatic oil reservoir with any light pneumatic tool
oil.
We recommend topping up the Pneumatic Oil Reservoir
periodically based on your use
e.g. ->
