8
11. Spread Keating Klenzer liberally on sides of fryer
vessel.
12. At this point, a non-abrasive scouring pad may be
used to remove the now softened carbonized
grease.
13. Thoroughly rinse fryer vessel with potable water
to remove all Klenzer.
14. Prior to refilling with oil, wipe the inside of the
fryer vessel making sure all water and Klenzer
has been removed.
WATER IN ANY FORM AND HOT OIL DON’T MIX!!!
15. Close drain valve.
FAILURE TO CLOSE DRAIN VALVE BEFORE
REFILLING THE FRYER MAY RESULT IN SERIOUS
INJURY.
WHEN YOUR FRYER IS BEING USED IN
CONJUNCTION WITH A
CENTRAL
FILTER,
DISCONNECT POWER SUPPLY
BEFORE
RESETTING MOTOR TO PREVENT SERIOUS
INJURY WHEN RESET SWITCH IS ENGAGED (SEE
FILTER MANUAL).
16. Check thermostat bulb positioning - see page 9.
17. Refill the fryer with new or filtered oil.
NOTE:
MSDS Sheets for Keating Klenzer, Sea
Powder & Acidox are available on-line at
www.keatingofchicago.com.
ELECTRONIC CONTROL
TIMERS
The electronic timers provide a clearly visible and
accurate display and are very easy to use.
ELECTRONIC TIMERS
Figure 3-6
A. PROGRAMMING
To program the timers, the unit must be in the idle
mode. Press and hold the set button for approximately
two seconds. The display will show “SEt”. Press T1, T2,
or T3 for the cook time to be programmed. The display
will show the current setting for that cook time. Use the
up or down button to increment or decrement the
setting. When the setting is correct, press and hold the
set button again for approximately two seconds. The
display will show "StO" for approximately two seconds
and the timer will return to normal operation. Repeat
the process as necessary for the other timers.
B. OPERATING LOGIC
When the timer is powered up, the display will show the
time setting for the cook time that was operated last
and the relay output contacts will be open. To start a
cycle, press the desired cook time button (T1, T2, T3).
The display will begin to countdown from the preset
time setting and the relay output contacts will close.
During the countdown the colon will flash at a one-
second rate. When the countdown has reached "00:00"
the relay output contacts will open, the display will
flash, and the audible alarm will sound. To cancel the
audible alarm, press any button.
C. PAUSE FEATURE
To pause a cycle in progress, press any button. The
relay output contacts will open, the display will flash,
and the countdown will pause. To resume the
countdown, press any button. The display will resume
the normal countdown and the relay output contacts
will close.
D. CANCELING A CYCLE
To cancel a cycle in progress press and hold any
button for approximately two seconds. The relay output
contacts will open and the display will show the time
setting for the cook time last used.
