|
keatingofchicago.com
SHUTDOWN
1. Turn ON/OFF switch to "off" position.
2. Rotate thermostat knob to left to "OFF"
position.
3. Turn gas valve knob to "OFF" position.
4. Check to determine that all burners and pilots
are
extinguished.
PREVENTIVE MAINTENANCE
Preventive maintenance should be done in daily, weekly,
monthly and yearly intervals as necessary. Following
preventive maintenance procedures will help keep your
MIRACLEAN® Griddle working effi ciently. Proper care and
servicing will lead to years of quality performance.
TIME FRAME
OPERATOR/OWNER
AT LEAST
DAILY
• Clean MIRACLEAN® Griddle surface.
• Drain and clean grease drawer.
• Completely wipe down cabinet.
AT LEAST
MONTHLY*
• Check MIRACLEAN® Griddle surface
to insure proper maintenance.
(Review proper cleaning procedures)
• Verify all thermostat settings.
• Review operating instructions
received with MIRACLEAN® Griddle.
TIME FRAME
QUALIFIED SERVICE PERSONNEL
AT LEAST
YEARLY*
• Have Miraclean® Griddle completely
checked, calibrated, tested,
cleaned, etc. by qualifi ed service
personnel. Be sure to check color
and height of pilot fl ame.
*
High production facilities should be checked more often.
Contact a local service company to perform maintenance and
repairs.
THERMOSTAT CALIBRATION
A. Limited Calibration (less than 10°C off)
You will need:
One standard fl at blade screwdriver
One accurate surface thermometer
1. Set thermostat to desired temperature (150°C
recommended).
2. Allow thermostat to cycle three times.
3. Locate “V” on front of griddle plate
(See Figure
3) above thermostat to be calibrated to locate ther-
mostat bulb position. Place thermometer on plate
over bulb half way toward rear of griddle.
4. If calibration of thermostat is found to be less
than 10°C off, simply loosen three dial plate retaining
screws, rotate dial plate to match thermometer read-
ing and tighten screws. If it is more than 10°C off,
use the following calibration procedures.
NOTE:
If thermostat is not maintaining an accurate
temperature, check bulb position. See fi gure 8 on
page 10 - THERMOSTAT BULB POSITIONING.
DO NOT ADJUST THE THERMOSTAT SET SCREW -
IT VOIDS ANY WARRANTY ON PART.
GRIDDLE SURFACE
With proper care, the MIRACLEAN® surface and its
unique cooking properties will last for many years.
However, dents or closely spaced nicks in the griddle
surface may cause the MIRACLEAN® surface to raise
where it could be torn when a spatula or scraper is
used. Care should be taken, as the damage done is
irreparable. See
page 7.
CLEANING
Proper care should be taken to fully clean the griddle on
a regular basis.
DISCONNECT ELECTRIC
POWER SOURCE BEFORE
CLEANING.
A. CONTROL PANEL -
Clean any grease build-up on
switches and thermostat knobs.
NOTE:
If grease gets into the body of a switch or ther-
mostat, it may cause it to fail.
B. CABINET -
The front, back and sides of the cabinet
should be kept clean for sanitary reasons.
8
Figure 6
Thermostat calibration
with knob on
