Parts List
The following parts are included in the KE2 Adaptive Control
controller kits:
Kit #
21177 with 120/208-240 VAC controller
(1) KE2 Adaptive Control controller
(1) high voltage safety shield
(1) 3-pack of colored 15’ temperature sensors
(6) 90° spade connectors
(2) straight spade connectors
(5) self-tapping screws
(2) 1/2” plastic knockout plug
(1) air sensor mount
(3) course thread screws
(1) KE2 Terminal Board*
(1) Warranty card
(not shown)
© Copyright 2016 KE2 Therm Solutions, Inc., Washington, Missouri 63090
Q.1.35
January 2016
KE2 Adaptive
Control
(pn 21177)
Quick Start Guide
Supplies List
The KE2 Adaptive Control is supplied with all of the accessories re-
quired for the controller to work, however, standard truck stock items
will also be required to install the controller. To simplify the installa-
tion, a list of items has been provided.
Conduit to go between the controller and the evaporator
(2) Conduit connectors (straight or elbow as required)
(8) High voltage wires matched to the load of the heaters,
fans, liquid line solenoid, and the controller.
(8) Spade Connectors matched to the gauge of high volt-
age wires
Wire labeling (numbers, colors, etc.)
Wire ties
18 gauge twisted shielded pair (if extending sensor wires)
Foam insulation if running wires outside the space.
Silicone (for sealing any box penetrations)
Accessories to Aid in Installation
The following parts are available separately:
10’ Wire Harness pn 20736, 25’ Wire Harness pn 20670, or 40’ Wire
Harness pn 20737
Further information on the Wire Harness can be found in literature
Q.1.21.
* When used with the KE2 Adaptive Control controller, the fuses must be sized to
match the application (i.e. Replace existing fuses with 30 Amp Time Delay fuses
for fans and compressor)
D
E
F
G
H
B
C
A
I
J
This reference should remain on site with the installed KE2 Adaptive Control controller.
A
C
D
E
F
G
H
I
B
J
