EN - 23
At any time it is possible to modify the time, phases, temperature, relative humidity and recirculation values. The
modi
fi cations will have immediate effect after programming or by not operating for 15 seconds.
The fresh air fan can also be activated or deactivated manually by pressing the key
ENTER
for a prolonged period.
I f the fan is active, a point appears on the display after Ri.
7.3.6b PROGRAMS CUSTOMI SATI ON
I t is possible to create customised program to satisfy the various seasoning requirements.
Customisation consists in creating the correct temperature, relative humidity and fresh air conditions in 6 programmable
spaces of time.
The spaces of time correspond to phases (f1 - f2 - f3 - f4 - f5 - f6).
To insert the desired values in every phase, proceed as follows:
By pressing the
MENU
key for a prolonged period, the
fl ashing letter P… followed by the number
of the program in progress will appear on the left display.
Use the
or
keys to scroll the program numbers. On reaching that desired, to
be modi
fi ed, press the
ENTER
key to con
fi rm the selection: pass automatically to phase ‘f1’
(
fl ashing). By pressing
or
increase or decrease the number of the phase to modify
the values of the set of the pre-selected program.
By pressing
ENTER
the temperature “t °C” is displayed (
fl ashing) of the phase in which you
are operating and with the
or
key modify the value.
ENTER
is used to memorise it,
passing automatically to the successive display: of the relative humidity (Rh % -
fl ashing).
To increase or decrease the set, act on the
or
keys again until reaching the desired
value.
Press
ENTER
to con
fi rm and pass to the next value to modify.
The display shows the duration value of the phase (
fl ashing). In the programs not yet used
OFF appears. Using the
key it is possible to set up to 96 hours with “h” and days with “d”.
Press
ENTER
to con
fi rm the duration of the phase and pass automatically to set fresh air in
the cell (Ri % -
fl ashing).
To modify the setting of the % value, act on the
or
keys.
Press
ENTER
to con
fi rm and pass to the following screen corresponding to the phase “f1”
(
fl ashing). With the
key increase to value to “f2”. From this phase, up to n°6, the values
are regulated by operating as previously described for “f1”.
On completion of insertion of the data, press the
MENU
key to memorise the cycle selected.
The phases in which a value equal to 0 will be skipped (the display shows‘OFF’).
NOTE
: By setting the duration of the phase at maximum value (599 d) the period results
set at in
fi nite “INF”. Every successive phase set will no longer be performed.
