10.6 Interior unit lighting
4
If the device is lighted by means of high-perfor-
mance-LED‘s, these can only be replaced by a quali-
fied specialist if they are defective. In this case, con-
tact the service department!
If the device is lighted by means of fluorescent lights,
proceed as follows:
TOP CROWN
• Undo the two screws at the facing of the “Tower
lighting in top crown” and remove the facing.
4
• Turn the lighting tube a quarter turn towards the
front and take it out towards the front.
• Replace the lighting tube and, if present, the colour
filter.
• Fasten the facing again.
DOOR
• Place a suction cup in the centre of the respective
pane and slowly pull the pane towards the front.
• Loosen the pane at one corner and go on down-
wards, then pull the pane off.
Caution
Place the door panel carefully on a pad-
ded surface.
There is one decorative tube beneath the door panel.
Turn the tube a quarter turn to the right and take it
out towards the front. Replace the tube, the colour
filter (if present) and the starter. Fasten door panel
again.
LATERAL PARTS
Dismantle the acrylic pane in the respective lateral
part as described in section “Acrylic panes”.
Remove the two front decorative tubes in the left
and right lateral part (they are marked in the illus-
tration below). Underneath you will find the lighting
equipment.
O p e r a t i n g I n s t r u c t i o n s
|
KBL Tower beautyShaper
36
Summary of Contents for beautyShaper
