O p e r a t i n g I n s t r u c t i o n s
|
KBL Tower beautyShaper
16
Table 4
Guidance and Manufacturer’s Declaration – Electromagnetic Immunity to Interference
The device is intended for use in the electromagnetic environment specified below. The studio operator of the
device should assure that it is used in such an environment.
Immunity tests
IEC 60601-
Test level
Compliance level
Electromagnetic environment
- Guidance
Portable and mobile RF communications
equipment should be used no closer
to the devive, including cables, than
the recommended separation distance
calculated from the equation applicable to
the frequency of the transmitter.
Site the device a miniumum of 24 inches
from any other electrical / electronical
devices to mitigate electro-magnetic efforts
between devices
Conducted RF disturbances
according to IEC 61000-4-6
3 V
eff
150 kHz to 80 MHz
10 V
eff
150 kHz to 80 MHz
3 V
eff
150 kHz to 80 MHz
10 V
eff
150 kHz to 80 MHz
Site the device a miniumum of 24 inches
from any other electrical / electronical
devices to mitigate electro-magnetic efforts
between devices
Radiated RF disturbances
according to IEC 61000-4-3
10 V/m
80 MHz to 1,0 GHz
10 V/m
1,4 GHz to 2,0 GHz
10 V/m
2,0 GHz to 2,7 GHz
10 V/m
80 MHz to 1,0 GHz
10 V/m
1,4 GHz to 2,0 GHz
10 V/m
2,0 GHz to 2,7 GHz
Field strengths from fixed RF transmitters,
as determined by an electromagnetic site
survey
a
shall be lower than the compliance
level in all frequency ranges.
Interference may occur in the vicinity of
equipment marked with the following
symbol:
a
Field strengths from fixed transmitters, such as base stations for radio telephones and land mobile radios, amateur radio,
AM and FM radio and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic envi-
ronment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in
the location in which the device is used exceeds the applicable RF compliance level above, The device should be observed
to verify normal operation in every location of use. If abnormal performance is observed, additional measures may be nec-
essary, such as reorienting or relocating the device unit.
Table 6
Recommended separation distances between portable and mobile
RF communications equipment and the device
The device is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled.
Site the device a miniumum of 24 inches from any other electrical / electronical devices to mitigate electro-
magnetic efforts between devices.
Summary of Contents for beautyShaper
