WARNING
Shock hazard.
Be sure AC power is not connected
before performing this procedure.
3
Place the Body Fan Mounting
Bracket behind the Body Fan
Bracket and secure with the
(2) 1/4-20 x 1/2” screws.
In this kit you should find the following parts:
SUPPORT RAILS
(under acrylic)
pg. 1
24735-02A
2
Slip the Body Fan into the Body Fan
Endcap, as shown. Be sure to insert
the wire connector into the rectangular
hole and route the wire in the groove
in the Body Fan Bracket.
Installing the Body Fan on a SUNSTAR ZX32
(With 3 Support Rails)
Before beginning this procedure... If your bench has three support rails under the bench acrylic, read this sheet.
If your bench has four rails, read the other sheet. You will need a #2 Phillips screwdriver to perform this procedure.
(4) - #10 x 1/2” Phillips pan head
sheet metal screws
(2) - 1/4-20 x 1/2” Phillips pan head
machine screws with lock washer
Body Fan
Mounting Bracket
Body Fan
Body Fan
Endcap
1
Open the bench acrylic shield and
remove the Foot End Bench Endcap
by removing the four screws that
hold it in place. Save these screws
to install the new endcap.
