KAYO MOTOR T2, Service Manual

Page: 27 / 61

ZHEJIANG KAYO MOTOR CO., LTD.
www.kayomoto.us - 26 -
5.Air filter
The air filter should be checked on time, as follows:
Remove the seat cushion;
Remove the air filter cover;
Check the air filter.
Installation is performed in the reverse order of removal.
Danger: The air filter should be cleaned regularly to prevent dust or dirt
from entering the engine, which may cause engine wear or even damage.
Filters should be cleaned in a well-ventilated area and ensure that there are
no sparks, flames, or strong heat sources in the workplace. Never use
gasoline to clean the filter.
Warning: If the filter is damaged, it must be replaced immediately,
otherwise dirt can enter the carburetor. When installing the air filter
lubricate all connections and threads.
seat
Air filter cover
6.Carburetor
Throttle screws and air screws allow idle speed adjustment of the
carburetor. The steps are as follows:
Turn the air screw clockwise until it reaches the top of its stroke and
reverse one and a quarter turns;
Adjust the throttle screw to ensure that the engine can idle at a steady speed
when the throttle is fully relaxed;
Adjust the throttle screw to reduce the engine speed as much as possible;
Adjust the air screw to make the engine speed as high as possible;
Repeat the above steps until a satisfactory speed is obtained;
Check if the throttle cable is working properly.
Danger: Driving a motorcycle with a damaged throttle cable is undoubtedly
a very dangerous behavior. A normal throttle cable should have a free travel
of at least 10mm. Start the engine and turn the handlebar left and right. If
the engine stalls or accelerates due to the movement of the handlebar, the
throttle cable is not adjusted properly or damaged. Make sure the throttle
throttle screw
air screw