Kayden CLASSIC 800 Series, Product Manual

Page: 17 / 77

ka yd en . c o m
9
Introd uction
CLASSIC 800 Product Manual
LOOP -
LOOP +
R2NC
R2NO
R2CM
R1 NC
R1 NO
R1 CM
VAC-H
VAC-N
COM
+VDC
485 (T)
485 (-)
485 (+)
485 (C)
LOOP +
4-20 mA Switch Power Supply,
sitive 1 2/24 VDC
LOOP - PLC U nipolar Voltage Input,
- 5 VDC
250 Ohm
Typical*
COM Switch Power Supply,
gative (Common)
+VDC Switch Power Supply,
sitive 1 2/24 VDC
LOOP -
LOOP +
R2NC
R2NO
R2CM
R1 NC
R1 NO
R1 CM
VAC-H
VAC-N
COM
+VDC
485 (T)
485 (-)
485 (+)
485 (C)
LOOP +
4-20 mA Switch Power Supply,
sitive 1 2/24 VDC
LOOP - PLC U nipolar Voltage Input,
- 5 VDC
Loop Power Supply,
Negative (Common)
GREEN G ROUNDING SCREW Safety Ground
VAC-H 1 1 5 VAC, Hot
VAC-N 1 1 5 VAC, Neutral
250 Ohm
Typical*
IV. 4-20 mA ANALOG OUTPUT
The 4 to 20 mA analog output signal is relativ e to the Thermal Signal displayed on the Thermal Signal Bar
Graph. The 0% to 1 00% of Thermal Signal corresponds to 4-20 mA or 20-4 mA.
Refer to View or Adjust
the 4-20 mA Output
for programming this option.
•
The 4-20 mA output signal corresponds to the scaled Thermal Signal v iew as determined by the
range (LED-0 and LED-1 00 pointers).
• The 4-20 mA signal may be displayed either as forward-acting (ascending 4-20 mA) or rev erse-
acting (descending 20-4 mA).
• To v iew or adjust the 4-20 mA output current configuration: (refer to the
Section 3, “View or
Adjust the 4-20 mA Output Configuration (Forward or Reverse)” or the “CLASSIC 800 Series
Quick Setup Guide”
MOUNTING BASE PLATE
MOUNTING BASE PLATE
AC INPUT
Figure 3 – 4-20 mA Wiring
1 . 4-20 mA output is passiv e (opto-isolated)
2. * 4-20 mA output current may be measured as a 1-5V v oltage
across a 250 Ohm resistor.
1. 4-20 mA output is passiv e (opto-isolated)
2. * 4-20 mA output current may be measured as a 1-5V v oltage
across a 250 Ohm resistor.
DC INPUT (3 or 4 Wire)
25472-1 01 -V1 A-JF00-W0010 Rev 02