ka yd en
. c o m
21
Setup & Opera tion
CLASSIC 800 Product Manual
I. GENERAL INFORMATION
1
. Warm up
At initial start-up or restart allow approximately 90 seconds for the heater element to warm up and the
switch/transmitter to stabilize before making any adjustments.
2. Diagnostics
As described in greater detail in
Section 7 “Troubleshooting”
an automatic diagnostic program runs
continuously when power is connected. To prev
ent the possibility of intermittent failures the CLASSIC 800
will display a Fault condition in the ev
ent of improper electrical connection, loss of power and / or
extensiv
e physical damage.
3. Universal Power
The CLASSIC 800 will accept either 1 2-24 VDC or 1 1 5-230 VAC but must be wired accordingly.
The CLASSIC 800 may not be loop powered. At a minimum the unit requires 4 wires: Hot and Neutral for
AC/DC, R1 COM and R1 NO (see Figure 1 2 - CLASSIC 800 Wiring Connection Diagram).
Power consumption for the CLASSIC 800 is rated at a maximum of 6 VA (watts). The maximum rating is
based on the assumption that both relays are energized, the heater is at maximum power and sev
eral
LEDs are illuminated. An application inv
olv
ing the relay energized and the heater at 80% power consumes
typically 300 mA or 4 VA.
4. Electronics
The CLASSIC 800 Electronics Module is univ
ersal and may be installed for testing or operation in all
CLASSIC 800 series switches/transmitters regardless of sensor configuration. Therefore, the Electronics
Module may be considered a univ
ersal spare part and the most essential troubleshooting tool for all
applications.
II. CONTROL SETTINGS and SETUP PROCEDURES
Quick Setup Guide
The CLASSIC 800 Quick Setup Guide,
Section 4 “Quick Setup Guide”
, contains the required information
to facilitate setup and adjustments. The setup procedures contained in
Section 3
of this manual are listed
in the same order as the programming matrix in the Quick Setup Guide which is included in this manual as
Section 4. Additional copies of the Quick Setup Guide may be obtained from kayden.com or your local
Kayden representativ
e.
25472-1 01 -V1 A-JF00-W0010 Rev 02
Summary of Contents for CLASSIC 800 Series
Page 2: ...25472 101 V1A JF00 W0010 Rev 02...
Page 3: ...25472 101 V1A JF00 W0010 Rev 02...
Page 73: ...kayden com 65 CLASSIC 800 CLASSIC 800 Product Manual Notes 25472 101 V1A JF00 W0010 Rev 02...
Page 74: ...kayden com 66 CLASSIC 800 CLASSIC 800 Product Manual Notes 25472 101 V1A JF00 W0010 Rev 02...
