kawneer.com
Laws and building and safety codes gover
ning the design and use of glazed
entrance, window
, and curtain wall pr
oducts vary widely
. Kawneer does not contr
ol
the selection of pr
oduct configurations, operating har
dwar
e, or glazing materials,
and assumes no r
esponsibility ther
efor
.
Kawneer r
eserves the right to change configuration without prior notice when deemed
necessary for pr
oduct impr
ovement.
© Kawneer Company
, Inc., 2011
5
PUSH
PANELINE
®
EXIT DEVICE
SERVICE INSTRUCTIONS
EC 97904-38
(PART NO. 038-371)
NOVEMBER, 2011
028-724
WASHERS (4)
Figure F
028-403
SCREWS (4)
028-403
SCREWS (4)
028-747
"X"
133-007
033-117
033-422
IMPORTANT:
BRUSH GREASE (033-203) ON ALL
SURFACES AS SHOWN BY THE DARK LINE.
INSTALLATION OF CHASSIS
1. Install and grease lever before chassis assembly.
IMPORTANT: Grease surfaces of lever as shown
2. Install chassis assembly using screws 028-403.
3.
Filler Plate Installation:
Equipment needed:
(4) Spring Clips per filler plate
Putty Knife
or
Small Straight Screw Driver
NOTE: Be careful not to scratch any finished surface of the Paneline.
4.
Installation Procedure: Dog down the unit!
Install the spring clips with the leg of the spring clip inserted into
the channel as shown.
Press down with your fingers until the spring clip engages completely.
Insert two spring clips at both the top and the bottom.
