kawneer.com
Laws and building and safety codes gover
ning the design and use of glazed
entrance, window
, and curtain wall pr
oducts vary widely
. Kawneer does not contr
ol
the selection of pr
oduct configurations, operating har
dwar
e, or glazing materials,
and assumes no r
esponsibility ther
efor
.
Kawneer r
eserves the right to change configuration without prior notice when deemed
necessary for pr
oduct impr
ovement.
© Kawneer Company
, Inc., 2011
8
2-27/32”
(72.2)
2-15/32”
(62.7)
3”
3”
(76.2)
(PART NO. 038-371)
EC 97904-38
NOVEMBER, 2011
PANELINE
®
EXIT DEVICE
SERVICE INSTRUCTIONS
UPPER LATCH
ASSEMBLY
LATCH ATTACHMENT
SCREWS
LOCK NUT
BEARINGS AND
RETAINING RINGS
TRAVELER
TRAVELER
HOUSING
TRAVELER
HOUSING
SCREW
LOCK NUT
LOWER LATCH
BOLT ASSEMBLY
LATCH ATTACHMENT
SCREWS
BOTTOM OF DOOR
1/2"
(12.7)
APPROXIMATELY
PULL HANDLE
MOUNTING SCREWS
PULL HANDLE
MOUNTING SCREWS
MOUNTING
STRAP
"190" DOOR
"350" DOOR
ROD LENGTH ADJUSTMENT
1. TYPE "190" AND "350" DOORS:
a. Remove push panel and chassis assembly and filler plates per instructions on pages 4 and 5.
b. Remove traveler housing and traveler to expose rod ends (see Figure H).
c. Check rod length dimensions per Figure G on page 5. If rod lengths are not correct, proceed to step "d" below.
d. Remove retaining ring and bearing from rod to be adjusted.
e. Remove (2) latch attachment screws and slide rod assembly out of door stile.
f.
Loosen lock nut and turn the threaded rod, clockwise to shorten, counterclockwise to lengthen (one revolution of
rod equals 3/64" (1.2) of travel). Align rod perpendicular to latch case and tighten lock nut.
NOTE: If one rod is adjusted, the other rod will probably require adjustment to maintain the 3" (76.2) separation
(see Figure I).
Figure H
Figure I
ROD ADJUSTMENT
