kawneer.com
Laws and building and safety codes gover
ning the design and use of glazed
entrance, window
, and curtain wall pr
oducts vary widely
. Kawneer does not contr
ol
the selection of pr
oduct configurations, operating har
dwar
e, or glazing materials,
and assumes no r
esponsibility ther
efor
.
Kawneer r
eserves the right to change configuration without prior notice when deemed
necessary for pr
oduct impr
ovement.
© Kawneer Company
, Inc., 2011
9
3"
(76.2)
2-27/32"
(72.2)
PANELINE
®
EXIT DEVICE
SERVICE INSTRUCTIONS
EC 97904-38
(PART NO. 038-371)
NOVEMBER, 2011
ROD ADJUSTMENT
ROD LENGTH ADJUSTMENT
2. TYPE "500" DOORS:
a. Remove push panel and chassis assembly and filler plates
per instructions on pages 4 and 5.
b. Remove traveler housing and traveler to expose rod ends
(see Figure H on page 6).
c. Check rod length dimensions per Figure J. If rod lengths
are not correct, proceed to step "d" below.
d. Remove (4) mounting strap spacer screws, (4) latch
attachment screws, (2) at top and (2) at bottom of door)
and lock cylinder, if so equipped, then slide complete rod
assembly out of door stile.
e. Loosen lock nut and turn the threaded rod, clockwise to
shorten, counterclockwise to lengthen (one revolution of
rod equals 3/64" (1.2) of travel).
NOTE:
If one rod is adjusted, the other rod will probably require
adjustment to maintain the 3" (76.2) separation (see Figure J).
Figure J
Figure K
"500" DOOR
LATCH
ATTACHMENT
SCREWS
STRAP
SPACER
SCREWS
MOUNTING
STRAP
PULL HANDLE
MOUNTING SCREWS
STRAP
SPACER
SCREWS
LATCH ATTACHMENT
SCREWS
BOTTOM OF DOOR
1/2"
(12.7)
APPROXIMATELY
3/32"
(2.4)
1/8"
(3.2)
3/32"
(2.4)
WHERE TO MEASURE WHEN ORDERING
VARIABLE PARTS FROM PAGES 8 AND 9.
NET DOOR OPENING
(D.O.)
SINGLE ACTING SHOWN
