![background image](http://html1.mh-extra.com/html/kawai/mp4/mp4_owners-manual_3977227042.webp)
42
8.2.8 LCD Contrast
This parameter adjusts the contrast of the LCD display.
As the value changes higher, the contrast gets sharper. The value changes
from 0 to 10.
8.2.9 LED Brightness
This adjusts the brightness of the LEDs. You can choose from High or Low.
The Low setting is designed for dark stages, while the High setting is good
for bright ambience.
8.2.10 Out Mode
Sometimes it is convenient to have two mono outputs instead of a stereo
output.
In this case one mono output can be used for your own monitor system and
the other goes to the mixing console.
Stereo:
The signal on the Line-Outs is normal stereo.
2xMono: The signal on the Line-Outs is mono on both jacks
Note:
To avoid unexpected sounding some stereo effects like AutoPan will be
turned off, when 2xMono is selected.
8.3 System Dump
8.3.1 Dump Current
This function transmits the current and active settings of the MP4 as a System
Exclusive Message via the MIDI OUT.
Press the SYSTEM button. Then press the MENU-UP button until “Dump
Current” appears on the display.
Press the VALUE-UP button. The display will ask for confirmation.
To cancel Dump Current at this point, press the VALUE-DOWN button.
Otherwise, press the VALUE-UP button again.
The display will change to read “Completed!!”. Dump Current is complete.
Note:
Loading the data back to the MP4 will change the current settings.
SETUP and SYSTEM data will not change.
You can use this function to
temporarily change the setting from your sequencer. If you want to
save the setting, you must use the STORE procedure and save as Setup.
8.3.2 Dump All
This function transmits all the Setups of the MP4 as System Exclusive
Messages via the MIDI OUT.
Use this function to backup your Setups on an
external MIDI sequencer.
Dump Current
Press VALUE UP
Dump Current
Sure?
Dump Current
Completed!!
SYSTEM
LCD Cont. = 10
SYSTEM
LED Bright.=High
SYSTEM
Out Mode =Stereo