KAULIN MFG. CO. Siruba LF-D6, Instruction Book / Parts List

Page: 18 / 42

-14-
4.
吹氣孔位置調整
調整送帶滾輪的左右方向 ( 方法見前述及圖
六 ), 使紅線對準鬆緊帶中央 ( 送帶用吹氣孔在
紅線的下方 ) ( 如圖 A) . 須注意 , 長輪有兩條紅
線 , 使用 1 英寸以下鬆緊帶時 , 使右邊紅線對準
鬆緊帶中央 ( 如圖 B); 使用 1 英寸以上鬆緊帶
時 , 使左邊紅線對準鬆緊帶中央即可 ( 如圖 C).
4.Adjust the position of blowing hole.
Adjust the feeding roller for aligning the
red line to the center of the elastic belt.
(The blowing hole of the feeding tape is
under the red line.)(As the diagram A) Be
aware that there are two red lines. For
using the elastic belt less than 1 inch,
have it align to the right red line (As the
diagram B); for using the elastic belt over
1 inch, have it align to the left red line. (As
the diagram C)
圖
C.(
長輪
)(
帶寬
1
英寸以上示意圖
)
Diagram C. (Long Roller)
(The diagram of the belt over 1 inch)
圖八 /FIG.8
圖
A.(
短輪
)
Diagram A. (Short Roller)
圖
B.(
長輪
)(
帶寬
1
英寸以下示意圖
)
Diagram B. (Long Roller)
(The diagram of the belt less than 1 inch)
鬆緊帶
Elastic Belt
紅線
Red Line
送帶吹氣孔
Feeding Blowing Hole
送帶吹氣孔
Feeding
Blowing Hole
鬆緊帶
Elastic Belt
紅線
Red Line
紅線
Red Line
送帶吹氣孔
Feeding
Blowing Hole
鬆緊帶
Elastic Belt