40 / 44
Installing and Connecting the Turntable
Pages 40 to 42 show the installation steps required to install the turntable (without the parabolic refl ector)
on the vehicle roof and the control unit inside the vehicle. All other detailed instructions in this operating
manual must also be observed.
1. Determine the installation place for the turntable.
Observe the following:
– Clean the installation place
– Mark out the installation place
2. Determine the installation place for the support.
Observe the following:
– Clean the installation place
– Mark out the installation place
3. Drilling the hole for the roof gland
– Drill a Ø 38 mm hole for the roof gland
– Deburr and clean the drill hole
4. Applying sealing adhesive and attaching the roof gland
– Insert the connecting piece into the bore
– Screw on the knurled nut
5. Applying sealing adhesive and attaching the support
– Press the support on with your hand
6. Unscrew the mounting plate from the turntable
– 6 screws (10 mm AF)
Risk of skin injuries!
►
Avoid any skin contact with the sealing adhesive.
►
Observe the safety information of the adhesive.
